Accessories
Controller-2WD and 4WD-900 Lite
The main controller that can support any type of dynamometer.
This module is avaliable only with new dynos.
Features:
– selectable brake controller output (PWM, RC-pulse, analog)
– 1x Load Cell input
– 1x RPM input
- 1x RPM Clamp Device Input
– 1x Wideband Lambda Input
– 1x Boost Pressure Annalog Input
- 1x Annalog 0-5V Input
- 1x CANBUS Input/Output
- 1x K-Type Input
- 1x OBD Input
- 1x Dynalink Remote KeyPad
- 2x Cooling Fan and Exhaust Fan OUTPUT control signal
– built-in weather station
Remote KeyPad
Design by DYNALINK!
one key to
Start
Stop
Calibration GearRatio
Adjust rpm up and down
Fan on Fan off
3 x Custom Functions by user
Features:
- 1x KeyPad - USB
DC-Power
The main controller that can support any type of dynamometer.
This module is avaliable only with new DYNALINK dynos.
Features:
– 30 Amp rating
– Calibrated linear current control
– high-speed SCR-based design
– high-speed discharge
– Over-current and over-temperature protection
– LED status indicators
– Housing with integrated heat sink, fan-less design
– Internal line and load filters to minimize noise generation
– Oversized components with respect to current and voltage ratings
– Very fast and reliable operation
WideBand Lambda Sensor
Use LSU 4.9 Lambda Sensor to input AFR/Lambda into our system.
Features:
- Measure dyno car AFR/Lambda
BOOST Sensor 0-7bar
0-7bar absolutely boost sensor
Features:
- Measure dyno car BOOST